Grass Valley UIM v.2.1.1 - Manual (Page 137)

February 5, 2008 UIM Instruction Manual 137
Installing the disk image on a replacement UIM
b. From the Available Adapters list, select the remaining Broadcom adapter and
then click Add .
7. Click Next .
The Designating a Standby Member page opens.
8. Do the following:
a. Select Use the following member as a standby member
b. From the list of adapter, select (0046) Broadcom… .
Leave Enable Auto Failback Disable Mode unselected
c. Click Next .
The Configuring a LiveLink page opens
9. Select No . Click Next .
The Configure VLAN Support page opens
10.Select No . Click Next .
The Congratulations page opens
11.Select Commit Changes… . Click Finish . When prompted, confirm with Yes and
OK .
12.In Broadcom Advanced Control Suite 2 tree-view, expand all nodes and then do
the following:
a. Under Primary Adapters, select a Broadcom adapter.
b. Click the Advanced tab.
c. In the Property box, select Flow Control .
d. In the Value drop-down list, select Rx/Tx PAUSE .
e. Repeat these steps for the other Broadcom adapter, which is under Standby
Adapters.
f. Click Apply . When prompted to confirm, click Yes .
13.Close the Broadcom Advanced Control Suite 2.
NOTE: The following steps are not required for the UIM-SAN-FCIP.
14.Open Device Manager as follows:
a. On the Windows desktop, right-click the My Computer icon (which has been
renamed with the UIM hostname) and select Manage . The Computer
Management window opens.
b. In the left pane select Device Manager . Device Manager opens in the right pane.
15.In Device Manager, expand the Network adapters node.
16.In Device Manager | Network adapters, right-click …MT Dual Port Server Adapter
and select Properties . The Properties dialog box opens.
17.Select the Teaming tab.