Grass Valley Kaleido-IP v.6.02 - Manual (Page 15)

Kaleido-IP
Quick Start Guide
11
8. Click Save.
The new settings are saved locally.
9. Click OK.
10. The Apply settings button becomes available.
11. Click Apply settings.
The multi-viewer must be restarted for changes to the network configuration to take effect. A message
appears prompting you to reboot the system immediately.
12. Click OK.
Network mask Must be set to the appropriate values, for the management and data
networks.
Default gateway If your management network is not configured with a gateway, clear the
default gateway IP address.
Detected link mode By default, all network adapters are set to auto-negotiate. The connection
speed and duplex mode will be set automatically based on the
corresponding port settings on the associated switch.
Configured link mode 1000 Mbps full-duplex communication can only be achieved via auto-
negotiation, as required by the IEEE-802.3 standard, section 28D.5. Should
your network configuration require specific speed and duplex mode
settings, select the appropriate value from the Configured link mode list.
Note: Settings cannot be applied to a multi-viewer system while an upgrade is in progress. If the multi-
viewer does not reboot after 10 seconds or so, try clicking Apply settings again after a minute or two,
until the multi-viewer reboots.