Polaris 2010 Victory Victory Vision 8-Ball - Manual (Page 107)

103
Pre-Ride
Pre-Ride Inspections
Hydraulic Clutch
1. Position the motorcycle on level ground in the fully
upright position. Position the handlebars so that the
clutch fluid reservoir is level.
2. View the fluid level through the sight glass. The fluid
should be clear. Replace cloudy or contaminated fluid.
3. The fluid level should be at or above the top of the sight
glass. Add DOT 4 brake fluid as needed. See page 176.
4. Squeeze and release the clutch lever. It should move
freely and smoothly, and it should return to the rest posi-
tion quickly when released. If the lever fails to perform
as stated, service the lever before riding.
5. Check for any signs of clutch fluid leaks around the
hoses, fittings, fluid reservoir and slave cylinder located
at the rear of the left engine (primary) cover.
Minimum
Level
Slave Cylinder
9922441.book Page 103 Monday, May 11, 2009 1:16 PM