Polaris 2010 Victory Victory Vision 8-Ball - Manual (Page 92)

88
Pr
e-
Ri
de
Pre-Ride Inspections
Turn the ignition key to the ON position and move the stop/run switch to RUN before per-
forming the following electrical inspections. Return the ignition key to the OFF position
after completing these inspections. If inspection of any electrical item reveals component
failure, repair or replace the component before operating the motorcycle.
Item Inspection Procedure
Electrical
Headlamp Tap the starter switch to verify that the headlamp illuminates. Switch to high
beam. Verify that the high beam indicator comes on and that lamp brightness
increases.
Taillight/Brakelight Verify that the taillight and license plate light illuminate. If a turn signal is acti-
vated, only the two lower lamps will illuminate. Verify that the taillight lamps
increase in brightness when the front brake lever is applied and also when the
rear brake pedal is applied.
Turn Signals Move the turn signal switch to the left. Verify that front and rear left turn signals
flash, as well as the corresponding light on the indicator panel. Push the switch
inward to cancel the signal. Verify that the signals and the indicator light stop
flashing. Repeat the procedure for the right turn signals.
9922441.book Page 88 Monday, May 11, 2009 1:16 PM