Polaris 2010 Victory Victory Vision 8-Ball - Manual (Page 212)

208
Maint
e
na
nce
Maintenance
Headlamp Bulb Replacement
1. Remove the air filter. See page 149.
2. Pull the sealing boot away from the back of the bulbs and housing.
3. Press the looped end of the wire bulb retainer clip and swing the end toward the center of
the bulb to release it from the latch tab.
4. With the wire connector attached, pull the bulb out.
Tip: When servicing a halogen lamp, avoid touching the lamp with bare fingers. Oil from your skin
leaves a residue, causing a hot spot that will shorten the life of the lamp. If fingers do touch a lamp,
clean it with denatured alcohol.
5. Disconnect the wire harness. Install the new bulb and secure the retainer.
6. Reinstall the sealing boot. Make sure it seals tightly around the bulb base and lens to pre-
vent condensation.
7. Reinstall the air filter.
08 Maintenance.fm Page 208 Monday, May 11, 2009 2:03 PM