HEIDENHAIN TNC 426B (280 472) ISO programming - Manual (Page 100)

84 5 Programming: Tools
5.2 T
ool D
ata
Editing functions for tool tables TNC 426, TNC 430 Soft key
Select beginning of table
Select end of table
Select previous page in table
Select next page in table
Look for the tool name in the table
Show tool information in columns or
show the information on one tool on one screen page
Move to beginning of line
Move to end of line
Copy the highlighted field
Insert the copied field
Add the entered number of lines (tools)
to the end of the table
Only TNC 426 B, TNC 430 with the NC software 280 474-xx:
Insert a line for the indexed tool number
after the active line. The function is only active if
you are permitted to store various compensation data
for a tool (machine parameter 7262 not equal to 0). The
TNC inserts a copy of the tool data after the
last available index and increases the index by 1
Delete current line (tool)
Display / Do not display pocket numbers
Display all tools / only those tools that are
stored in the pocket table
Editing functions for Tool Table TNC 410 Soft key
Select previous page in table
Select next page in table
Move highlight to the left
Move highlight to the right
Lock tool in TL column
Do not lock tool in TL column
Confirm actual positions, e.g. for
Z axis
Confirm entered value
Select next column in the table
Delete incorrect value, restore
previous value
Restore last value stored
Fkap5.pm6 29.06.2006, 08:06 84