HEIDENHAIN TNC 426B (280 472) ISO programming - Manual (Page 98)

82 5 Programming: Tools
5.2 T
ool D
ata
Tool table: Tool data required for automatic tool measurement
(only conversational programming)
Abbr. Input
CUT. Number of teeth (20 teeth maximum)
LTOL Permissible deviation from tool length L for
wear detection. If the entered value
is exceeded, the TNC locks the tool(status L).
Input range: 0 to 0.9999 mm
RTOL Permissible deviation from tool radius R for
wear detection. If the entered value
is exceeded, the TNC locks the tool(status L).
Input range: 0 to 0.9999 mm
DIRECT. Cutting direction of the tool for measuring the tool
during rotation
TT:R-OFFS Tool length measurement: tool offset between
stylus center and tool center. Preset value:
Tool radius R
TT:L-OFFS Tool radius measurement: tool offset in addition
to MP6530 (see „14.1 General User Parameters)
between upper surface of stylus and lower
surface of tool.
Preset value: 0
LBREAK Permissible deviation from tool length L for
breakage detection. If the entered value is exceeded,
the TNC locks the tool (status L).
Input range: 0 to 0.9999 mm
RBREAK Permissible deviation from tool radius R for
breakage detection. If the entered value is exceeded,
the TNC locks the tool (status L).
Input range: 0 to 0.9999 mm
Dialog
Number of teeth ?
Wear tolerance: length ?
Wear tolerance: radius ?
Cutting direction (M03 = –) ?
Tool offset: radius ?
Tool offset: length ?
Breakage tolerance: length ?
Breakage tolerance: radius ?
Abbr. Input
DOC Comment on tool (up to 16 characters)
PLC Information on this tool that is to be sent to the PLC
Only TNC 426, TNC 430 with NC Software 280 474-xx
PLC-VAL
Value of this tool that is to be sent to the PLC
Dialog Width of column
Tool description?
PLC status?
PLC value?
Fkap5.pm6 29.06.2006, 08:06 82