HEIDENHAIN TNC 426B (280 472) ISO programming - Manual (Page 185)

169 HEIDENHAIN TNC 410, TNC 426, TNC 430
Point table TAB1.PNT
TAB1 .PNT MM
NR X Y Z
0 +10 +10 +0
1 +40 +30 +0
2 +90 +10 +0
3 +80 +30 +0
4 +80 +65 +0
5 +90 +90 +0
6 +10 +90 +0
7 +20 +55 +0
[END]
N120 T2 G17 S5000*
N130 G01 G40 Z+10 F5000*
N140 G200 Q200=2 Q201=-25 Q206=150 Q202=5
Q210=0 Q203=+0 Q204=0*
N150 G79 “PAT“ F5000 M3*
N160 G00 G40 Z+100 M6*
N170 T3 G17 S200*
N180 G00 G40 Z+50*
N190 G84 P01 +2 P02 -15 P030 P04 150*
N200 G79 “PAT“ F5000 M3*
N210 G00 G40 Z+100 M2*
N99999 %1 G71*
Call the drilling tool
Move tool to clearance height (enter a value for F)
Cycle definition: drilling
The value 0 must be entered with Q203 and Q204.
Cycle call in connection with point table TAB1.PNT
Retract the tool, change the tool
Tool call for tap
Move tool to clearance height
Cycle definition for tapping
Cycle call in connection with point table TAB1.PNT
Retract in the tool axis, end program
8.3 Dr
illing Cy
cles
Kkap8.pm6 29.06.2006, 08:06 169