HEIDENHAIN iTNC 530 (340 49x-01) ISO programming - Manual (Page 154)

154 5 Programming: Tools
5.2 T
ool D
a
ta
Pocket table for tool changer
For automatic tool changing you need the pocket table TOOL_P.TCH.
The TNC can manage several pocket tables with any file names. To
activate a specific pocket table for program run you must select it in
the file management of a Program Run mode of operation (status M).
In order to be able to manage various magazines in a tool-pocket table
(indexing the pocket number), Machine Parameters 7261.0 to 7261.3
must not be equal to 0.
Editing a pocket table in a Program Run operating mode
8 To select the tool table, press the TOOL TABLE soft
key.
8 To select the pocket table, press the POCKET TABLE
soft key.
8 Set the EDIT soft key to ON.
The machine tool builder adapts the functional range of
the pocket table to the requirements of your machine. The
machine tool manual provides further information.