HEIDENHAIN iTNC 530 (340 49x-01) ISO programming - Manual (Page 494)

494 12 MOD Functions
12.5 Set
ting the D
a
ta Int
e
rf
aces
Assign
This function sets the destination for the transferred data.
Applications:
„ Transferring values with Q parameter function D15
„ Transferring values with Q parameter function D16
The TNC mode of operation determines whether the PRINT or PRINT
TEST function is used:
You can set PRINT and PRINT TEST as follows:
File names
TNC mode of operation Transfer function
Program Run, Single Block PRINT
Program Run, Full Sequence PRINT
Test run PRINT TEST
Function Path
Output data via RS-232 RS232:\....
Output data via RS-422 RS422:\....
Save data to the TNC’s hard disk TNC:\....
Save the data in the same directory as the
program with FN15/FN16. - vacant -
Data Operating mode File name
Values with D15 Program run %FN15RUN.A
Values with D15 Test run %FN15SIM.A
Values with D16 Program run %FN16RUN.A
Values with D16 Test run %FN16SIM.A