HEIDENHAIN iTNC 530 (340 49x-01) ISO programming - Manual (Page 577)

Ve00
533 188-20 · SW01 · 10 · 12/2004 · F&W · Printed in Germany · Subject to change without notice
DR. JOHANNES HEIDENHAIN GmbH
Dr.-Johannes-Heidenhain-Straße 5
83301 Traunreut, Germany
{ +49 (8669) 31-0
| +49 (8669) 5061
e-mail: [email protected]
Technical support | +49 (8669) 31-10 00
e-mail: [email protected]
Measuring systems { +49 (8669) 31-3104
e-mail: [email protected]
TNC support { +49 (8669) 31-3101
e-mail: [email protected]
NC programming { +49 (8669) 31-3103
e-mail: [email protected]
PLC programming { +49 (8669) 31-3102
e-mail: [email protected]
Lathe controls { +49 (711) 952803-0
e-mail: [email protected]
www.heidenhain.de
3-D Touch Probe Systems from HEIDENHAIN
help you to reduce non-cutting time:
For example in
workpiece alignment
datum setting
workpiece measurement
digitizing 3-D surfaces
with the workpiece touch probes
TS 220 with cable
TS 640 with infrared transmission
•
•
•
•
tool measurement
wear monitoring
tool breakage monitoring
with the tool touch probe
TT 130
•
•
•