Defining a cycle using soft keys, 1 w o rk ing with cy cles – HEIDENHAIN iTNC 530 (340 49x-01) ISO programming User Manual
Page 237
HEIDENHAIN iTNC 530
237
8.1 W
o
rk
ing with Cy
cles
Defining a cycle using soft keys
8
The soft-key row shows the available groups of
cycles.
8
Press the soft key for the desired group of cycles, for
example DRILLING for the drilling cycles.
8
Select a cycle, e.g. DRILLING. The TNC initiates the
programming dialog and asks all required input
values. At the same time a graphic of the input
parameters is displayed in the right screen window.
The parameter that is asked for in the dialog prompt
is highlighted.
8
Enter all parameters asked by the TNC and conclude
each entry with the ENT key.
8
The TNC ends the dialog when all required data has
been entered.
Example NC block
N10 G200 DRILLING
Q200=2
;SET-UP CLEARANCE
Q201=3
;DEPTH
Q206=150
;FEED RATE FOR PLUNGING
Q202=5
;PLUNGING DEPTH
Q210=0
;DWELL TIME AT TOP
Q203=+0
;SURFACE COORDINATE
Q204=50
;2ND SET-UP CLEARANCE
Q211=0.25
;DWELL TIME AT DEPTH