HEIDENHAIN iTNC 530 (340 49x-01) ISO programming - Manual (Page 543)

HEIDENHAIN iTNC 530 543
13.3 T
e
c
hnical Inf
o
rm
ation
Software option 1
Rotary table machining  Programming of cylindrical contours as if in two axes
„ Feed rate in length per minute
Coordinate transformations  Tilting the working plane
Interpolation  Circle in 3 axes (with tilted working plane)
Software option 2
3-D machining † Motion control with minimum jerk
† 3-D compensation through surface normal vectors
† Using the electronic handwheel to change the angle of the swivel head during program
run without affecting the position of the tool point (TCPM = Tool Center Point
Management)
† Keeping the tool normal to the contour
† Tool radius compensation normal to the direction of traverse and the tool direction
† Spline interpolation
Interpolation † Line in 5 axes (subject to export permit)
Block processing time † 0.5 ms