HEIDENHAIN iTNC 530 (340 49x-01) ISO programming - Manual (Page 60)

60 2 Manual Operation and Setup
2.2 Mo
ving the Mac
h
ine Ax
es
Features in the Program Run Modes of Operation
You can use the following functions in the Program Run modes of
operation:
„ NC start (handwheel NC-start key)
„ NC stop (handwheel NC-stop key)
„ After the NC-stop key has been pressed: Internal stop (handwheel
soft keys MOP and then STOP)
„ After the NC-stop key has been pressed: Manual axis traverse
(handwheel soft keys MOP and then MAN)
„ Returning to the contour, after the axes were moved manually
during a program interruption (handwheel soft keys MOP and then
REPO
). Operation is by handwheel soft key, which function similarly
to the control-screen soft keys (see “Returning to the contour” on
page 483)
„ On/off switch for the Tilted Working Plane function (handwheel soft
keys MOP and then 3D)