HEIDENHAIN iTNC 530 (340 49x-01) ISO programming - Manual (Page 483)

HEIDENHAIN iTNC 530 483
1
1
.4 Pr
ogr
am r
u
n Returning to the contour
With the RESTORE POSITION function, the TNC returns to the
workpiece contour in the following situations:
„ Return to the contour after the machine axes were moved during a
program interruption that was not performed with the
INTERNAL STOP function.
„ Return to the contour after a block scan with RESTORE POS AT N,
for example after an interruption with INTERNAL STOP.
„ Depending on the machine, if the position of an axis has changed
after the control loop has been opened during a program
interruption.
8 To select a return to contour, press the RESTORE POSITION soft
key.
8 Restore machine status, if required.
8 To move the axes in the sequence that the TNC suggests on the
screen, press the machine START button.
8 To move the axes in any sequence, press the soft keys RESTORE X,
RESTORE Z, etc., and activate each axis with the machine START
key.
8 To resume machining, press the machine START key.