Yaskawa F7 to L1000A - Manual (Page 53)

(Header Title) Application Note
Doc#: PL.L1000A.01 Copyright Yaskawa Electric America, Inc. ©2010 www.yaskawa.com September 9, 2010 53 of 57
Subject: Transition Guide Product: L1000A Document: PL.L1000A.01
Title: Product Transition Guide – F7 to L1000A
Product Transition Guide – F7 to L1000A
F7 L1000A
Parameter Name
Parameter Default
Setting
Record
Parameter Default
Comments: Gray shading indicates default setting.
Traction Sheave Diameter ─ ─ o1-20 400 mm Scales the display unit calculations.
Roping Ratio ─ ─ o1-21 2 Sets the ratio (1:1, 1:2, 1:3 or 1:4)
Mechanical Gear Ratio ─ ─ o1-22 * Determined by the control method.
LOCAL/REMOTE Key
Function Selection
o2-01 1 o2-01 0
F7 L1000A
o2-01 o2-01
0: Disabled 0: Disabled
1: Enabled 1: Enabled
STOP Key Function Selection o2-02 1 o2-02 0
F7 L1000A
o2-02 o2-02
0: Disabled 0: Disabled
1: Enabled 1: Enabled
User Parameter Default Value o2-03 0 o2-03 0
F7 L1000A
o2-03 o2-03
0: No change 0: No change
1: Save values 1: Save values
2: Clear memory 2: Clear memory
Drive Model Selection o2-04 * o2-04 *
Do not change this setting.
Determined by drive capacity.
Frequency Reference Setting
Method Selection
o2-05 0 o2-05 0
F7 L1000A
o2-05 o2-05
0: ENTER required 0: ENTER required
1: ENTER key not required 1: ENTER key not required
Operation Selection when
Digital Operator is
Disconnected
o2-06 0 o2-06 0
F7 L1000A
o2-06 o2-06
0: Disabled 0: Disabled
1: Enabled 1: Enabled
Cumulative Operation Time
Setting
o2-07 0H o4-01 0H ─
Cumulative Operation Time
Selection
o2-08 0 o4-02 0
F7 L1000A
o2-08 o4-02
0: Whenever the power is
on
0: Whenever the power is
on
1: During run only 1: During run only
Factory Tuning o2-09 0 o2-09 * *Do not change this setting.
Fan Operation Time
(L1000A: Cooling Fan
Operation Time Setting)
o2-10 0H o4-03 0H
F7 Setting Range : 0 to 65535H
L1000A Setting Range : 0 to 9999H
Fault Trace, Fault History
Reset
o2-12 0 o4-11 0
F7 L1000A
o2-12 o4-11
0: No change 0: No change
1: Reset U2, U3 parameters 1: Reset U2, U3 parameters
Multi-Function
Sele
ctio
n
kWh Monitor Initialize
Selection
o2-14 0 o4-12 0
F7 L1000A
o2-14 o4-12
0: No change 0: No change
1: Reset the kWh monitor 1: Reset the kWh monitor