Yaskawa VS-616G5 Modbus Plus Communication Card - Manual (Page 13)

Installation of the MB+ Board 3-3
Figure 3-1. MB+ Board Mounting Position
7. Locate the green grounding wire with mounting lug on the MB+ board. Route this wire to the
lower corner of the drive control board.
8. Connect the green wire (labeled “E”) to terminal 12 on the drive.
NOTE:
You have completed the mechanical installation of the MB+ board. Proceed to the MB+
board configuration prior to applying input power or replacing the VS-616G5 front cover.
Spacer
Holes
Ground
Terminal
(term. 12)
DIP Switch
SW1
Connector
2CN
Main
Control
Terminals
Modbus
Plus
Interface
Board