Yaskawa P7 Metasys N2 - Manual (Page 28)

Cable Loss Behavior 4-4
Metasys N2 Analog Output (AO) Summary
Table 4.2 – Metasys N2 Analog Output Summary (Metasys N2 to P7U)
Object ID Object Name Units Default Value P7U Parameter
AO 1 SPEED COMMAND 0.01 Hz -
AO 2 ACCELERATION TIME SEC 30.0 C1-01
AO 3 DECELERATION TIME SEC 30.0 C1-02
AO 4 PI PROPORTIONAL GAIN - 2.00 b5-02
AO 5 PI INTEGRAL TIME SEC 5.0 b5-03
AO 6 STALL PREVENTION LEVEL – RUN % 120 L3-06
AO 7 STALL PREVENTION LEVEL – ACCEL % 120 L3-02
AO 8 REFERENCE OPERATION MODE SELECT - 1 b1-01
AO 9 RUN OPERATION MODE SELECT - 1 b1-02
AO 10 PI MODE SELECT - 0 b5-01
AO 11 FREQUENCY COMMAND UPPER LIMIT % of MAX 100.0 d2-01
AO 12 FREQUENCY COMMAND LOWER LIMIT % of MAX 0.0 d2-02
AO 13 MOTOR RATED CURRENT A Motor model dependent E2-01
AO 14 JUMP FREQUENCY 1 0.1Hz 0.0 d3-01
AO 15 JUMP FREQUENCY 2 0.1Hz 0.0 d3-02
AO 16 JUMP FREQUENCY 3 0.1Hz 0.0 d3-03
AO 17 JUMP FREQUENCY BANDWIDTH 0.1Hz 1.0 d3-04
AO 18 NUMBER OF AUTO RESTARTS - 0 L5-01
AO 19 OPERATOR DISPLAY MODE - 0 o1-03
AO 20 POWER LOSS RIDE THROUGH SEC Drive model dependent L2-02
AO 21 CABLE LOSS TIME-OUT SEC 2.0 H5-09
AO 22 CABLE LOSS SPEED 0.01Hz 0.00 d1-04
AO 23 PI INTEGRAL LIMIT 0.1% 100.0 b5-04
AO 24 PI UPPER LIMIT VALUE 0.1 100.0 b5-06
AO 25 PI OFFSET ADJUSTMENT 0.1 0.0 b5-07
AO 26 PI PRIMARY DELAY TIME 0.01 0.00 b5-08
AO 27
PI FEEDBACK REFERENCE
MISSING DETECTION SELECT
1 0 b5-12
AO 28
PI FEEDBACK REFERENCE
MISSING DETECTION LEVEL
1% 0 b5-13
AO 29
PI FEEDBACK REFERENCE
MISSING DETECTION TIME
0.1 SEC 1.0 b5-14
AO 30 READ PARAMETER NUMBER - -
AO 31 WRITE PARAMETER NUMBER - -
AO 32 WRITE PARAMETER DATA - -