Yaskawa P7 Metasys N2 - Manual (Page 38)

P7 Bypass Applications 6-4
Table 7.1 - Typical Bypass/Engineered Drive Parameters
Bypass Settings Parameter
Number
Default User
Description
H1-05 8 hex Terminal S7 Function (External Base Block (N.O.))
H2-02 3B hex Terminal M3-M4 (Command Source – Serial)
H3-08 2 Terminal A2 (0–10vdc)
H3-09 2 Terminal A2 (Auxiliary Frequency Reference)
H3-12 0.3 sec Analog Input Filter Time
H3-13 0 Master Frequency Reference Terminal Select (0 – Terminal A1)
L2-01 2 Momentary Power Loss Detection Select (2 – CPU power active) (UV fault not detected)
L4-05 1 Frequency Reference Loss Detection Select (1 – RUN @ 80% of frequency prior to loss)
L5-01 10 Number of Re-Start Attempts
L5-03 600.0 sec Maximum Restart Time After Fault
L6-01 6 Torque Detection Select (6 – No Load Detect and Alarm)
L6-02 15% Torque Detection Level (% of drive rated current)
L6-03 10.0 sec Torque Detection Time
L8-03 4 Overheat Pre-Alarm Operation Select (4 – Alarm and Reduce)
L8-11 300 sec Heatsink cooling Fan Operation Delay Time
L8-19 20% Overheat Frequency Reference Reduction Level
o2-01 0 Local/Remote Key Function (0 - Disabled)
o2-02 0 OFF Key Function (0 – Disabled)
o2-05 1 Frequency Reference Setting Method select (1 – Enabled) (Enter key Not Required from Keypad)
o2-08 1 Cumulative Operation Time Select (1 – Time @ RUN)
o3-02 1 Keypad COPY Function Select (1 – Enabled)