Enterasys Networks Fast Network 10 - Manual (Page 116)

Appendix A: Technical Specifications
Page A-4 Fast Network 10 User Guide
A.4 STRAIGHT-THROUGH WIRING
If the twisted-pair link segment is to join two ports on a switch, and only
one of the ports has an internal crossover, the two pairs of wires must be
straight-through, as shown in Table A-2.
a. The “+” and “-” signs are used to
represent the polarity of the two wires that
make up each wire pair.
Table A-1 Pin Assignments
Pin Assignment
a
1 Tx+
2 Tx-
3 Rx+
6 Rx-
Table A-2 Straight-through RJ45 Pin Assignments
Hub Device
1 (Tx+) 1 (Tx+)
2 (Tx-) 2 (Tx-)
3 (Rx+) 3 (Rx+)
6 (Rx-) 6 (Rx-)