Enterasys Networks Fast Network 10 - Manual (Page 72)

Chapter 4: Monitoring and Managing Your FN10
Page 4-12 Fast Network 10 User Guide
To display all MAC addresses, at the LCM prompt:
1. Type addresses display any
LCM responds with a list of all MAC addresses, their associated ports,
the type, age, and number of frames from and to that address.
If you do not specify any , only the learned static and other addresses are
displayed.
To display a specific address, at the LCM prompt:
1. Type addresses display <MAC-ADDRESS>
For example, if you typed, addresses display 02:04:06:03:2a:43 ,
LCM would display the following information:
You can display a range of addresses by using a net mask. This is helpful
when determining the status associated with stations containing the same
make of Ethernet network interface cards. At the LCM prompt:
1. Type addresses display <MAC-ADDRESS> <NET-MASK>
For example, to see all addresses that begin with 02:04:06, you would
enter:
addresses display 02:04:06:00:00:00 ff:ff:ff:00:00:00
Address Type Port Age(secs) Frames-From Frames-To
08:00:20:02:3a:44
00:40:27:03:b7:21 Learned
Static 3
** 26
5
1
17110
0
195
Enter <CR> to continue, Ctrl-C to exit:
Address Type Port Age(secs) Frames-From Frames-To
02:04:06:03:2a:43 Learned 5 21 1181
73