Enterasys Networks Fast Network 10 - Manual (Page 75)

Using LCM to Manage the FN10
Fast Network 10 User Guide Page 4-15
4.5 USING LCM TO MANAGE THE FN10
The LCM commands that enable you to manage the FN10 include:
• Disable
• Enable
• Ipaddr
• Community
• Baud
• Reboot
These LCM commands are described in the sections that follow.
4.5.1 Disabling a Port
There can be times when you need to disable a specific Ethernet port, for
example, after you have determined that there is faulty equipment.
Disabling a port effectively stops all bridging functions for that port.
Disabled ports do not accept SNMP packets, and therefore cannot
communicate with an NMS.
To disable a port, or port range, at the LCM prompt:
1. Type disable <PORT-RANGE>
For example, disable 7-9 would disable ports 7, 8, and 9.
LCM responds:
Once an Ethernet port is disabled, it will be disabled until you enable it
again. Resetting the FN10 will not enable a port that has been disabled.
Port 7: Disabled
Port 8: Disabled
Port 9: Disabled