Enterasys Networks Fast Network 10 - Manual (Page 87)

Port Filters
Fast Network 10 User Guide Page 5-7
For example, if you had the configuration shown below, the And operator
assigned to Port 2 would apply to the next instance of Port 2, not
necessarily the next sequential filter number in the Port Filter Table index.
The Port filter configuration fields are described in Table 5-2.
Table 5-2 Port Filter Configuration Fields
Field Description Default
Port
If the filter is for port 1, you do not need to enter
anything. If the filter is for another port, enter that
number.
1
Type
Either Entry – apply the filter to all packets received
on the port, or Exit – apply the filter before
transmitting the packet from the port.
Entry
Port/
Group
Match
Either NA (not applicable), True – filter the packet if
the receiving port or group number matches, or False
– filter the packet if the receiving port or group number
does not match. This is valid only if the filter type is
Exit.
NA
Port/
Group #
Decimal value for the number of the port or group
through which the packet entered the FN10 XE. This is
valid only if the filter type is Exit. Port group numbers
start at 25.
NA
Source
Range
Either NA (not applicable), True – filter the packet if
the source MAC address is within the range, or False
– filter the packet if the source MAC address is
outside of the range.
NA
1
2
3
4
5 1
2
1
2
2 Or
And
Or
Or
Or
Filter
Index Filter
Port Filter
Operator