Enterasys Networks Fast Network 10 - Manual (Page 79)

Using LCM to Manage the FN10
Fast Network 10 User Guide Page 4-19
To display the current baud rate setting, at the LCM prompt:
1. Type baud
LCM responds:
To change the baud rate setting, at the LCM prompt:
1. Type baud <baud rate>
For example, baud 9600 would set the baud rate to 9600.
LCM responds:
4.5.6 Setting a Reboot Time
You can enter the number of seconds the FN10 waits before rebooting. At
the LCM prompt:
1. Type reboot <time interval>
For example, reboot 60
LCM responds:
Usage: baud [1200|2400|4800|9600|19200]
Baud rate is 4800.
Baud rate is 9600.
System will be reset in 60 seconds.