Enterasys Networks Fast Network 10 - Manual (Page 57)

Assigning a Community Name
Fast Network 10 User Guide Page 3-15
To delete a workgroup, at the LCM prompt:
1. Type workgroup NAME delete
To create or modify the port list for a specific workgroup, at the LCM
prompt:
1. Type workgroup NAME PORT-RANGE
To modify the network classification of a specific workgroup, at the LCM
prompt:
1. Type workgroup NAME INFO
3.9 ASSIGNING A COMMUNITY NAME
A community name is similar to a password. You use the same steps to
assign a new community name or to change an existing community name.
This sets the MIB variable
sxadminAnyPass . You can then enter a
community name to perform any SNMP sets. The default password is an
empty string that allows you to enter your community name.
To assign a community name, at the LCM prompt:
1. Type community
2. Enter the old community name.
If one has not been assigned, you do not need to enter anything. LCM
prompts you for the new community name.
3. Enter the new community name.
LCM prompts you to verify the new community name by retyping it.
4. Retype the new community name.