Epson 7900p - Manual (Page 106)

106 Maintaining the Projector
7. Loosen the two screws holding the lamp in place (you don’t need
to remove them).
8. Grasp the wire handle as shown and pull the lamp straight out.
9. Gently insert the new lamp.
10. Once the lamp is fully inserted, tighten its screws and replace the
cover. (The projector won’t come on if the lamp cover is loose.)
11. Reset the lamp timer as described in the next section.
note
The lamp(s) in this
product contain mercury.
Please consult your state and
local regulations regarding
disposal or recycling. Do not
put in the trash.
When you get a replacement
lamp for your projector, new
air filters are included. This
is a good time to install them
(see page 104).