Epson 7900p - Manual (Page 99)

Managing the Projector from a Remote Computer 99
6. Select ON for the Mail Notification setting.
7. Enter the IP address and port number of the SMTP server used
for sending e-mail. (The port’s default setting is 25, but you can
enter any number from 1 to 65535.)
8. Enter up to three e-mail addresses where you want the event
notification messages to be sent.
9. Click the Setting a Notification Event button next to each
address, then select the conditions under which you want a
message to be sent.
10. Click OK , then click OK again on the next screen. Click Set on
the Setup for Network Projector screen and confirm as needed.
11. When you see the test message window, you can send a message
with the heading “TEST MAIL” to the addresses you have
entered. The projector’s name and IP address are included in the
body of the message.
12. When done making all your projector settings, close EMP
NetworkManager. (It does not have to be open for messages to be
sent or received.)
Understanding the Notification Messages
If a projector experiences a problem, it sends an e-mail message to
each of the addresses you provided using EMP NetworkManager. The
message includes the heading “EPSON Projector” in the subject line.
The body of the message contains:
■ the name of the projector
■ the projector’s IP address
■ a description of the problem
The problem descriptions are similar to the errors reported by EMP
Monitor listed on page 94.
If a plus (+) sign appears before the description, it indicates that a
problem has occurred. A minus (–) sign appears when the problem
goes away or is resolved.
note
A no-signal message is
reported when no image
signals are being input to a
projector. If the projector
will not normally be
displaying an image, do not
select ‘no signal’ as a
condition for which you
want a message to be sent.
note
If a projector develops a
critical problem, it may not
be possible for it to report the
error.