Epson 7900p - Manual (Page 37)

Projecting 37
4. Press the red P Power button on top of the projector—or press
the P Power button on the remote control.
(If this is your first time using the remote control, make sure the
batteries are installed and the on/off switch on the side of the
remote is turned on; see page 52.)
The PPower light flashes green as the projector warms up, and
an image begins to appear. When the PPower light stops flashing
and remains green (in about 20 seconds) the projector is ready
for use.
5. If you’ve connected a Windows-based computer to the projector,
you may see a New Hardware Wizard saying your computer has
found a plug-and-play monitor; if so, click
Cancel .
Turn on
remote
Power button
warning
Never look into the lens
when the lamp is on. This
can damage your eyes, and is
especially dangerous for
children.
note
If the Direct Power ON
feature has been enabled,
you don’t need to press the
P
Power button to turn
the projector on. Just plug
the projector into an
electrical outlet. When the
P
Power light stops flashing
and stays on, the projector is
ready to use.