Epson 7900p - Manual (Page 88)

88 Managing the Projector from a Remote Computer
3. Press the Menu button on the remote control and select Network
from the Advanced2 menu.
4. If your network assigns addresses automatically, turn on DHCP .
5. If your network does not assign addresses automatically, turn off
DHCP and enter the projector’s IP Address , Subnet Mask ,
Gateway Address , and MAC Address , as needed.
■ To enter numbers using the remote control, press the Num
button until it lights, then use the number keypad shown
below.
Brightness Control Brightness Control High High Low Low : Video Video
Audio Audio
Setting Setting
User's Logo User's Logo
Advanced1 Advanced1
About About
Reset All Reset All
Projector ID Projector ID
Network Network
Reset Reset Execute Execute
: 1 : 1
[Menu]: Exit [Menu]: Exit [ ]: Enter [ ]: Enter [ ]: Select [ ]: Select
Effect Effect
Advanced2 Advanced2
COM Port COM Port
BNC Sync Termination BNC Sync Termination
:
ON ON OFF OFF :
Set Set
Set Set
RS-232C RS-232C USB USB
Auto setup Auto setup ON ON OFF OFF :
Select Network
note
If you’re a network
administrator, you can use
the
SNMP option to enter a
trap IP address. This lets you
receive trap alerts for the
projectors you’re monitoring.
If you have HP OpenView,
a plug-in will be available
to allow you to manage your
projectors in HP OpenView.
Check with your dealer or
Epson for availability (see
page 121).
Num button
Zero