Epson Stylus Scan 2500 - Manual (Page 19)

19
Checking the Stylus Scan
English
The ink charging process takes about one minute to complete, during which time
the Operate light flashes and the Stylus Scan produces a variety of mechanical
sounds. These sounds are normal. When the ink delivery system has been charged,
the print head returns to its home (far right) position and the Operate light stays on.
c
Caution:
Never turn off the EPSON Stylus Scan while the Operate light is
flashing.
■ Checking the Stylus Scan
Before using your EPSON Stylus Scan, make sure it is working correctly by printing
a nozzle check pattern. You may also need to clean the print head.
❚ Loading Paper
Follow these steps to load A4 size plain paper in the paper feeder. The Stylus Scan
prints onto this paper when printing and making copies.
1. Slide out the output tray. Next, slide the left edge guide so that the distance between
the edge guides is slightly wider than the width of your paper. If you load long
paper, pull out the paper support extension.
2. Fan a stack of paper; then tap it on a flat surface to even the edges.
3. Load the stack of paper with the printable side up and the right edge of the paper
resting against the right side of the sheet feeder. Slide the left edge guide against
the edge of the paper.
Note:
❏
Always load paper into the sheet feeder short edge first.
❏
Make sure the paper stack fits under the arrow mark inside the edge guide.
edge guide output tray
printable side up