Epson WorkForce Pro WF-R8590 DTWF - Manual (Page 21)

Group Policy Setting Items
Items Settings and Explanation
Enable this Group Policy You can enable or disable a group policy.
Access Control Configure a control method for traffic of IP packets.
Permit Access Select this to permit configured IP packets to pass through.
Refuse Access Select this to refuse configured IP packets to pass through.
IPsec Select this to permit configured IPsec packets to pass
through.
Local Address(Printer) Select an IPv4 address or IPv6 address that matches your network environment. If an IP
address is assigned automatically, you can select Use auto-obtained IPv4 address.
Remote Address(Host) Enter a device's IP address to control access. The IP address must be between 0 and 43
characters. If you do not enter an IP address, all addresses are controlled.
Note:
If an IP address is assigned automatically (e.g. assigned by DHCP), the connection may
be unavailable. Configure a static IP address.
Method of Choosing Port Select a method to specify ports.
Service Name If you select Service Name for Method of Choosing Port, select an option.
Transport Protocol If you select Port Number for Method of Choosing Port, you need to configure an
encapsulation mode.
Any Protocol Select this to control all protocol types.
TCP Select this to control data for unicast.
UDP Select this to control data for broadcast and multicast.
ICMPv4 Select this to control ping command.
Administrator's Guide
Using the Printer in a Secure Network
21