Epson EB-1460Ui - Manual (Page 11)

Installation Guide
10
Installation Work Flow
Installing one projector
Follow the procedures below to mount the projector on a wall.
a Installing the Setting Plate and the Projector ( s p.32 )
b Adjusting the Position of the Projector ( s p.46 )
c Calibrating the Interactive Pen ( s p.54 )
d Installing the Control Pad and the Pen Stand ( s p.61 )
When installing the Touch Unit, finish installing the projector first, and then follow the procedures below.
(EB-1460Ui/EB-1450Ui only)
The procedure differs depending on where the Touch Unit is to be installed.
When installing the Touch Unit outside the whiteboard (using the Touch Unit Bracket)
a Installing the Touch Unit ( s p.64 )
b Adjusting the Angle of Laser Diffusion ( s p.69 )
c Performing Touch Calibration ( s p.84 )
When installing the Touch Unit on the whiteboard (without using the Touch Unit Bracket)