Attma gauge calibration pressure pre-sets, 10 automatic save 1.11 create a new test file, 10 automatic save – Retrotec FanTestic (ATTMA) User Manual
Page 17: 11 create a new test file
rev-2014-10-27
Page 17 of 58
©Retrotec Inc. 2011-2014
ATTMA gauge calibration pressure pre-sets
The Gauge Calibration will be based on the number of points and on the range of pressures you specify
in this pre-set option (either 7 points or 11 points as indicated). This affects what shows up in the
“Gauge Calibration” window which opens when you enter a gauge calibration for a particular gauge
serial number (see section 3.8.2).
Start FanTestic if it is not already running.
Click on “Settings” “Advanced - view or change default program parameters”
Click on “Application” tab.
1.10 Automatic Save
Test data can be automatically saved at periodic intervals by turning the Auto Save function on (“File”
“Auto save?”).
Test files are normally saved on your local C: drive under [MyDocuments]\Retrotec\Tests.
If you change the location of the test file to a remote drive, and then remove the remote drive with
FanTestic running and AutoSave on, the software will not be able to save the file to the remote drive
anymore, and may report an error.
Turn AutoSave Off if you wish to double click to launch test files attached to emails. If you double click
on a file with extension .exml attached to an email in MS Outlook with AutoSave on, FanTestic will start
up and open the test file, but when AutoSave tries to save to the inaccessible MS Outlook temporary
location, FanTestic may report an error.
1.11 Create a new Test file
To create a new test, click on “New test” at the top of the history list, or go to “File” “New”.