RIGOL M300 - Manual (Page 72)

RIGOL
© 2007 RIGOL Technologies, Inc.
User’s Guide for DM3000 Series
2-24
To Set up the VMC
At external triggering mode, when the data sampling is over, the instrument outputs
a pulse signal at VM Comp located on the rear panel. The output pulse width can be
adjusted.
Press  VMC, the display shows:
Figure 2- 20 Set the Output Polarity
Table 2- 19 Menu Description
Function
Menu
Setting Description
Polar
Pos
Neg
Setting the pulse signal’s polarity.
PWidth Setting the pulse width.
Store the changing and back to
the higher menu.
The VMC function output
(1). At external triggering mode, when the data sampling is over, the instrument will
output a pulse signal to indicate operation completed.
(2). At external triggering mode, when operating math limited value, the instrument
will export a pulse signal to indicate out of limits detected.