TA Triumph-Adler DC 2020 - Manual (Page 100)

Page 3-57
3-4 TWAIN Source
8 Status field…Indicates the current status of the scanner.
9 Scan/Connect button…If your computer is successfully connected to the scanner, the Scan button will
appear. Once you click this button, the scanning operation will start. If your computer is not connected
properly to the scanner, this button will appear as a Connect button to enable you to reconnect to the
scanner.
10 Waiting Scan checkbox…If there is a check mark in the Waiting Scan checkbox, the scanner is in the
Scan mode but in an operation-pause state. In this case, you will need to press the Start key on the
scanner’s operation panel in order to initiate scanning.
11 Default button…Click to return all of the settings in the TWAIN source back to their factory default values.
12 Scan Setup button…Click to display the Scan. Setup Dialogue Box. (Refer to page 3-58.)
13 Cancel button…Click to cancel the currently entered settings and close the Main Dialogue Box.
14 Help button…Click to display the Help Screen.