TA Triumph-Adler DC 2023 - Manual (Page 141)

6-5
Turning Dial Confirmation ON/OFF
Dial Confirmation enables the prevention of problems associated
with mistakenly pressing the wrong one-touch, program or group dial
key. When Dial Confirmation is turned ON, you will be able to check
the destination before dialling occurs, thereby preventing your
documents from being sent to the wrong party.
● If Dial Confirmation is turned ON…
Pressing a one-touch, program or group dial key will not initiate
dialling. Rather, information such as the destination fax number or
the program registered under that key will be shown in the message
display to allow dialling only after you have checked the displayed
information. (Refer to <Operation with Dial Confirmation turned ON>.)
● If Dial Confirmation is turned OFF…
Dialling will start immediately upon pressing the one-touch, program
or group dial key.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
1. Press the CONFIGURE key.
2. Use the cursor up or the cursor down key to select “Confirm dial”.
3. Press the Enter key.
4. Use the cursor up or the cursor down key to select whether to turn
Dial Confirmation ON or OFF.
* The asterisk (*) in the message display indicates the current
setting.
5. Press the Enter key. The setting for Dial Confirmation is complete.
* If you are finished making settings, press the Reset key.
The operation panel will return to the initial mode settings.
Section 6 Various Settings and Registration in this Fax
3A180100A
3A1/FaxSystem(A)/MCE-Eng
/ 164
<Operation with Dial Confirmation turned ON>
[Ex.] A single fax number is registered under the one-touch key
1 Press the one-touch key that is registered with the desired fax
number.
2 Check the destination name and/or fax number shown in the
message display.
3 If the destination IS the one desired, press the key on the
keypad that corresponds to the number indicated in the bottom
line of the message display.
* If you pressed the wrong one-touch key, press the Reset key
and perform the procedure once again from the beginning.
01-DEC-1999 12:00
Set original
v :Newcastle
Document :A4
Press 5-key
Confirm dial:
➪ On
*Off
Set fax:
Nr of rings : 2Times
Nr rings-TAD :10Times
➪
Confirm dial :On
Confirm dial:
➪ On
*Off
Set fax:
Nr of rings : 2Times
Nr rings-TAD :10Times
➪ Confirm dial :Off
Set fax:
End
➪
TTI :Outside p.
Print report P
06/Setting/3A1/MCE/Eng.q 23-12-1999 14:28 Page 6-5