TA Triumph-Adler DC 2315 User Manual

Page 34

Advertising
background image

Section 4 BASIC OPERATION

4-2

5

Adjusting the copy exposure
The copy exposure can be manually adjusted in all of the
image quality modes, except for the Auto Exposure
Adjustment mode. If you want to make the exposure
darker, press the right exposure adjustment key to move
the lit indicator to the right. If you want to make the
exposure lighter, press the left exposure adjustment key to
move the lit indicator to the left.

NOTE

The copy exposure scale can be set to either 5 or 7 levels
of adjustment. (See “Exposure Steps” on page 6-1.)

6

Setting the number of copies to be made
Press the Number of Copies / Zoom(+) key if you want to
increase the number of copies to be made and the Number
of Copies / Zoom(-) key if you want to decrease the number
of copies to be made. You can also press the Number of
Copies / Zoom(-) key for at least 3 seconds to shift the
number of copies to be made from “1” up to “99” in one step,
or the Number of Copies / Zoom(+) key to shift the number
of copies to be made from “99” to “1”. Make sure the desired
number of copies to be made is shown on the copy
quantity/magnification display. The setting can be made to
any number up to “99”.

NOTE

It is possible for you to limit the number of copies or copy
sets that can be made at one time. (See “Copy Limit” on
page 6-3.)

7

Setting an original
Open the original cover and set the original that you want
to copy face-down onto the platen. Be sure to align the
original flush up against the left rear corner of the platen.

NOTES

• If the optional Document Processor is installed on your

copier, set the original(s) in the Document Processor.
(See “Document Processor” on page 7-1.)

• Shadows may appear around the edges and up the

middle of copies made from open-faced originals (such
as books, etc.).

• When the copier is in a copy-ready state, the optical

lamp will be lit. This does NOT indicate trouble with
the copier.

8

Start copying
Press the Start key. Copying will begin immediately once
the Start indicator is lit green.

Advertising