TA Triumph-Adler DC 2315 - Manual (Page 39)

Section 4 BASIC OPERATION
4-7
The Off mode automatically turns most of the power to the copier
off if no operation has been performed on the copier for a pre-set
period of time (between 15 and 240 minutes). “-” will be shown on
the copy quantity/magnification display, but everything else on the
operation panel will go out.
The factory default setting is for 30 minutes.
It is possible to engage the Off mode manually.
Press down on the Reset/Power key for at least 3 seconds.
The Off mode will engage immediately.
NOTE
When the Off mode is engaged, all power to the copier,
except that to the operation panel, is turned off. When
the power switch is turned OFF ({), all power to the
copier, including to the operation panel, is turned off.
To enable copying again, press any one of the keys on the operation
panel.
More about the Off mode
The Off mode is a power-saving feature which automatically turns
most of the power to the copier off when a certain time elapses
without any operation being performed.
Copiers are generally in a standby mode more than they are in
actual operation, so power consumption during this standby period
occupies a large part of overall consumption. Having the copier
enter the Off mode automatically after a certain amount of time
reduces unnecessary power consumption during the standby period
or at night if the copier happens to be left on accidentally. The
result is a lower electricity bill.
NOTES
• It is possible to set the amount of time before the Off
mode engages. (See “Off Mode Time” on page 6-4.)
• It is also possible to disable the Off mode. (See “Off
Mode ON/OFF” on page 6-4.)
Off mode