TA Triumph-Adler DC 2315 - Manual (Page 54)

Section 6 COPY DEFAULT SETTINGS
6-4
F21 Off Mode ON/OFF Sets whether the Off mode (see page 4-7),
which automatically turns most of the power
to the copier off when a certain time elapses
without any operation being performed, will
engage automatically or not.
* If the Off mode interferes in any way with
your copying operations, turn this function
OFF. It is recommended, however, that you
try to set a longer time interval until the Off
mode engages before you actually turn it
OFF.
ON*
OFF 6-6
6-7
F22 Auto Clear Time Sets the amount of time after each copy job is
finished until the Auto Clear function (see
page 2-5) automatically engages. 10 – 270 (seconds)
(Default: 90 seconds) 6-6
6-9
F23 Low Power Mode Time Sets the amount of time after each copy job is
finished until the Low Power mode (see
page 4-6) automatically engages. 1/5/15/30/45/60/90/120/
180/240 (minutes)
(Default: 15 minutes) 6-6
6-9
F24 Off Mode Time Sets the amount of time without any operation
being performed until the Off mode (see
page 4-7) automatically engages. It is also
possible to disable the Off mode. When the Off
mode is turned OFF, this default setting will
not appear. (See “Off Mode ON/OFF”)
* If the Off mode is turned off under the “Off
Mode ON/OFF” setting, this default setting
will not appear.
* It is recommended that you try to set a
longer time interval before the Off mode
engages if you use the copier frequently, and
to a shorter time if it is used less frequently.
* In order to disable the Off mode, see “Off
Mode ON/OFF”.
15/30/45/60/90/120/180/
240 (minutes)
(Default: 30 minutes) 6-6
6-9
F25 Alarm ON/OFF Sets whether the alarm which sounds when an
error occurs, etc., will be turned ON or OFF. ON
OFF* 6-6
6-7
F26 Document Processor
Leading Edge Timing
Adjustment Adjusts the location of the copied image if it is
shifted off-center (either forward or backward)
when the Document Processor is used to make
copies.
* If the optional Document Processor is not
installed on your copier, this default setting
will not appear.
-32 – 32 (1-step
increments)
(Each one-step adjustment
is equal to a 0.3 mm shift.)
(Adjustment is complete
at the time of purchase.) 6-6
6-11
Item
number
Default Description Available settings
Reference
page