PLANET WGSD-10020 - Manual (Page 30)

User’s Manual of WGSD / WGSW Layer 2+ Series
■ Console Port
The console port is a DB9, RS-232 male serial port connector. It is an interface for connecting a terminal directly. Through
the console port, it provides rich diagnostic information including IP address setting, factory reset, port management, link
status and system setting. Users can use the attached RS-232 cable in the package and connect to the console port on the
device. After the connection, users can run any terminal emulation program (Hyper Terminal, ProComm Plus, Telix,
Winterm and so on) to enter the startup screen of the device.
2.1.2 LED Indications
The front panel LEDs indicates instant status of port links, data activity and system power; helps to monitor and troubleshoot
when needed. Figure 2-8 and Figure 2-113 show the LED indications of these Managed Switches.
WGSD-10020 LED indication
Figure 2-8 LED Panel of WGSD-10020
System
LED Color Function
PWR Green Lights to indicate that the Switch has power.
Per 10/100/1000Mbps port
LED Color Function
1000
LNK/ACT
Green
Lights to indicate the port is running at 1000Mbps speed and successfully established.
Blink s to indicate that the switch is actively sending or receiving data over that port.
10/100
LNK/ACT
Green
Lights to indicate the port is running at 10/100Mbps speed and successfully established.
Blink s to indicate that the switch is actively sending or receiving data over that port.
Per 100/1000BASE-X SFP interfaces
LED Color Function
1000 Green
Lights to indicate the link through that port is successfully established.
Blink s to indicate that the switch is actively sending or receiving data over that port.
100 Green
Lights to indicate the link through that port is successfully established.
Blink s to indicate that the switch is actively sending or receiving data over that port.
30