PLANET HPOE-1200G - Manual (Page 5)

1. INTRODUCTION
1.1 Package Contents
CHECK THE CONTENTS OF YOUR PACKAGE FOR THE FOLLOWING PARTS:
●
PoE Injector Hub x 1
●
Quick Installation Guide x 1
●
User’s Manual CD x 1
●
Power Cord x 1
●
Rubber Feet x 4
●
Two Rack-mounting Brackets with Attachment Screw x 1 (set)
If any of these are missing or damaged, please contact your dealer immediately; if possible, retain the carton including the
original packing material, and use them again to repack the product in case there is a need to return it to us for repair.
In the following section, the term “PoE Injector Hub” means the two Gigabit PoE Injector Hub devices, i.e. HPOE-1200G
and HPOE-2400G. The term “injector” means any IEEE 802.3at / 802.3af power injectors. “PD” means IEEE 802.3at /
802.3af powered device.
1.2 Product Description
The PoE Injector Hub is a 12- / 24-port IEEE 802.3at / 802.3af Power over Ethernet Mid-Span injector hub which complies
with IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3at and IEEE 802.3af standards. It is equipped with 12 / 24
10/100/1000Mbps Gigabit Ethernet ports that support full 52V DC power for any remote IEEE 802.3at / 802.3af powered
device (PD) like 802.11b/g/n wireless LAN access point, IP phone, LAN camera or any other network device. The PoE
Injector Hub should provide sufficient 30.8-/15.4-watt power per port to the 12 / 24 remote PD devices with 360-/720-watt
power supply.
The PoE Injector Hub is installed between a regular Ethernet switch and the powered devices, injecting power without
affecting the data transmission. It offers a cost-effective solution and quick way to upgrade the network system to IEEE
802.3at / 802.3af Power over Ethernet, without replacing the existing Ethernet Switch.
There are 24 / 48 RJ-45 STP ports on the front panel of PoE Injector Hub, of which 12 / 24 of them on the lower stack are
"Data" ports and the other 12 / 24 ports on the upper stack are "Data + Power output" ports. Each of the "Data + Power
output" ports on upper stack functions act as an injector which inserts DC Voltage into the CAT 5e/6 cable allowing the
cable between the Injector and Splitter to transfer data and power simultaneously.
To manage your powered devices, the PoE Injector Hub provides both Web management interfaces in which
administrators can manage functions such as port Enable/Disable, port priority, limit, schedule, system configuration,
change of Username/Password and smart feature for powered device. The PoE Injector Hub can auto-detect the power
status on each port and show messages of Web management interface. These features also provide a cost-effective way
to manage the devices from Internet whenever you are at work or at home.
5
User’s Manual of HPOE-1200G / HPOE
2400G