PLANET IGS-504HPT - Manual (Page 16)

16
2.1.4 Wiring the Power Inputs
The 6-contact terminal block connector on the top panel of Industrial Gigabit PoE+
Switch is used for two DC redundant powers input. Please follow the steps below
to insert the power wire.
1. Insert positive/negative DC power wires into contacts 1 and 2 for Power 1, or 5
and 6 for power.
1 2 3 4 5 6
V1- V1+ V2 - V2+
2. Tighten the wire-clamp screws for preventing the wires from loosening.
1 2 3 4 5 6
Power 1 Fault Power 2
- + - +
Note
The wire gauge for the terminal block should be in the range
between 12 and 24 AWG.