PLANET IGS-504HPT - Manual (Page 24)

24
2.2 Mounting Installation
This section describes how to install the Industrial Gigabit PoE+ Switch and make
connections to it. Please read the following topics and perform the procedures in
the order being presented.
Note
In the installation steps below, this Manual uses IGS-801 (PLANET
8 Port Industrial Gigabit Switch) as the example. However, the
steps for PLANET Industrial Gigabit PoE+ Switch are similar.
2.2.1 DIN-rail mounting
The DIN-rail is screwed on the Industrial Gigabit Ethernet Switch when out of
factory. When needed to replace the wall mount application with the DIN-rail
application on Industrial Gigabit Ethernet Switch, please refer to the following
figures to screw the DIN-rail on the Industrial Gigabit Ethernet Switch. To hang the
Industrial Gigabit Ethernet Switch, follow the steps below:
Step 1: Screw the DIN-rail on the Industrial Gigabit Ethernet Switch.