PLANET MC-1610MR - Manual (Page 31)

4.4.3.1 Set slot [n]
This command allows configuring per slot parameters of Managed Media Converter Chassis, different parameters provide on
FST-8 / GST-7 / GST-8 Media Converter boards installation. The correct usage is shown as below:
Set slot [n]: n=1-16, to configuring per slot parameters of Managed Media Converter Chassis. The configuring per slot pa-
rameters screen in Figure 4-16 appears and the detail description shown in table 4-2 & 4-3 & 4-4 .
Figure 4-16 Set slot [n] command screen
Item Description
Device To enable or disable per FST-80x Converter board.
LLCF To enable or disable the LLCF function from FST-80x Converter board.
TP AN Mode To set the UTP port runs at Auto-negotiation or Forced Mode.
TP Speed ＊ To set the UTP port runs at 100Mbps or 10Mbps.
TP Duplex ＊ To set the UTP port runs at Full duplex or Half duplex mode.
TP Flow Control To set the Flow Control of the UTP port to enable or disable.
Fiber LLR To enable or disable the LLR function of the Fiber port.
Fiber Duplex To set the Duplex Mode of Fiber port to Full duplex or Half duplex mode.
Table 4-2 Descriptions of the FST-80x slot Configuration screen Objects
Item Description
Device To enable or disable per GST-70x Converter board.
Fiber LLR To enable or disable the LLR function of the fiber port.
Fiber AN Bypass To set the Auto negotiation bypass function of the fiber port to enable or disable.
Table 4-3 Descriptions of the GST-70x slot Configuration screen Objects
31