PLANET WNAP-7200 - Manual (Page 13)

Before you proceed with the installation, it is necessary that you have enough information
about WNAP-7200.
1. Please connect right installation “PoE” port of PoE inject to WNAP-7200; “LAN” port of
PoE injector to LAN PC, wrong installation will cause the device damage.
Note: Strongly suggest using SFTP cable, for better protection of the data wire.
25-meter SFTP cable also available by order, the part no is CB-STP-25.
Please contact with local dealer for more information.
2. Using Category 3 or higher UTP or STP cable, connect the “LAN” port of PoE Injector to a
10Mbps or 10/100Mbps Ethernet hub or switch, and connect the PC on the same LAN for
management.
3. Locate an optimum location and use the provided Mounting kit to tie the WNAP-7200 to a
pole.
Note: 1. To avoid thunder strike, consider installing ELA-100, thunder arrester
toward the CPE AP and the PoE injector.
2. For secured reason, while install the CPE AP, please be aware for the
electric wires around, and tighten the pole. Without tighten the CPE AP,
the pole and the installed site is with electric wire around, there could be
danger of being hurt by falling or lethal injury.
4. Connect the 12V 1.25A DC power adapter to the PoE Injector socket, and plug it into an
AC outlet to power on the WNAP-7200.
Note: 1. The PoE Injector is a passive device. It will inject the DC power into the
UTP cable right away once you connect the DC-plug in to the DC-jack
of the PoE Injector.
2. DONOT connect the PoE Injector labeled as POE port to any devices
but WNAP-7200, otherwise it will damage the device permanently.
5. For Ethernet port application, please refer to user’s manual for bridge, gateway and WISP
application for the first installation, LAN port is suggested.
Note: 1. ONLY use the power adapter supplied with the WNAP-7200. Otherwise,
the product may be damaged.
2. Strongly suggest using STP cable whether the cable exposed outdoor
for waterproof and avoiding thunder stroke.
13