PLANET WNAP-7200 - Manual (Page 55)

4.6.2 Port Forwarding
You may setup virtual servers to provide service on internet.
Virtual Server Setting:
Enable/Disable the port forward.
IP Address:
This is the port number on the WAN side that will be used to access the application. You
may define a single port or a range of ports. You can use a comma to add multiple ports or
port ranges.
Port Range:
This is the port used to forward the application. It can be either a single port or a range of
ports. For the TCP and UDP services enter the beginning of the range of port numbers used
by the service. If the service uses a single port number, enter it in both the start and finish
fields.
Protocol:
Select the protocol (TCP, UDP, or TCP & UDP) used to the remote system or service.
Comment:
You may key in a description for the IP address.
55