PLANET WNAP-7200 - Manual (Page 25)

Wireless Network
Radio On/Off:
Enable or disable the wireless LAN.
Network Mode:
There are 11n only and 11a/g mixed mode.
Network Name (SSID):
The service set identification (SSID) is a unique name to identify the router in the wireless
LAN. Wireless stations associating to the router must have the same SSID. Enter a
descriptive name. Its length is up to 32 characters.
Multiple SSID 1/2/3/4/5/6/7:
There are 7 multiple SSIDs. Enter their descriptive names that you want to use.
Broadcast Network Name (SSID):
Select Enable to allow the SSID broadcast on the network, so that the STA can find it.
Otherwise, the STA can not find it.
AP Isolation:
Enable or disable AP Isolation. When many clients connect to the same access point, they
can access each other. If you want to disable the access between clients which connect the
same access point, you can enable this function.
MBSSID AP Isolation:
Enable or disable MBSSID AP Isolation.
BSSID:
Basic Service Set Identifier. This is the assigned MAC address of the station in the access
point. This unique identifier is in Hex format and can only be edited when Multi BSSID is
enabled in the previous screen.
Frequency (Channel):
A channel is the radio frequency used by wireless device. Channels available depend on
your geographical area. You may have a choice of channels (for your region) and you
should use a different channel from an adjacent AP to reduce the interference. The
Interference and degrading performance occurs when radio signals from different APs
overlap.
Wireless Distribution System (WDS)
WDS Mode:
Enable or disable the WDS function.
25