PLANET WNAP-7350 - Manual (Page 100)

User Manual of WNAP-7350
-93-
IEEE 802.11n: 24 ± 1dBm
Receiver Sensitivity
IEEE 802.11a: -91dBm
IEEE 802.11n: -92dBm
Output Power Control 3~27dBm
Software Features
Built-in DHCP server supporting static IP address distributing
LAN
Supports 802.1d STP (Spanning Tree)
WAN
 Static IP
 Dynamic IP
 PPPoE
 PPTP
 L2TP
 IPSec
Operating Mode
 Bridge
 Gateway
 WISP
NAT firewall with SPI (Stateful Packet Inspection)
Built-in NAT server supporting Virtual Server and DMZ Firewall
Built-in firewall with Port / IP address / MAC / URL filtering
Wireless Mode
 AP
 Client
 WDS PTP
 WDS PTMP
 WDS Repeater (AP+WDS)
Channel Width 20MHz / 40MHz
Wireless Isolation
Enable it to isolate each connected wireless clients from communicating with
each other mutually.
Encryption Type 64/128-bits WEP, WPA, WPA-PSK, WPA2, WPA2-PSK, 802.1X
Provides wireless LAN ACL (Access Control List) filtering
Wireless MAC address filtering
Supports WPS (WIFI Protected Setup )
Wireless Security
Enable / Disable SSID Broadcast
Multiple SSID Up to 2
Max. Wireless Client 40
Max. WDS AP 8
Max. Wired Client 60
WMM Supports Wi-Fi Multimedia
QoS Supports Quality of Service for bandwidth control
NTP Network Time Management
Management Web UI, DHCP Client, Configuration Backup & Restore, Dynamic DNS, SNMP
Diagnostic tool System Log, Ping Watchdog
Mechanical & Power
IP Rate IP67