PLANET WNRT-627 - Manual (Page 85)

User’s Manual of WNRT-627
-78-
Figure 5-33 Local Management
By default, the radio button “ All the PCs on the LAN are allowed to access the Router's
Web-Based Utility” is checked. If you want to allow PCs with specific MAC Addresses to access the
Setup page of the Router's Web-Based Utility locally from inside the network, check the radio button
“ Only the PCs listed can browse the built-in web pages to perform Administrator tasks”, and
then enter each MAC Address in a separate field. The format for the MAC Address is
XX-XX-XX-XX-XX-XX (X is any hexadecimal digit). Only the PCs with MAC address listed can use the
password to browse the built-in web pages to perform Administrator tasks while all the others will be
blocked.
After click the Add button, your PC's MAC Address will be placed in the list above.
Click the Save button to save your settings.
If your PC is blocked but you want to access the Router again, use a pin to press
and hold the Reset Button (hole) on the back panel for about 5 seconds to reset
the Router’s factory defaults on the Router’s Web-Based Utility.