PLANET WRT-416 - Manual (Page 20)

z
WAN Access Type:
1. Static IP address
Your ISP has given you an IP address already
2. DHCP Client
Your ISP will automatically give you an IP address.
3. PPPoE
Your ISP requires PPPoE connection.
4. PPTP
Your ISP requires you to use a Point-to-Point Tunneling Protocol (PPTP) connection.
z MTU
The MTU (Maximum Transmission Unit) setting specifies the largest packet size permitted for network
transmission. Most DSL users should use the value 1492.You can set MTU manually, and you should
leave this value in the 1200 to 1500 range. If the value you set is not in accord with the value ISP
provide, it may causes some problems, such as fail to send Email, or fail to browse website. So if that
happen, you can contact your ISP for more information and correct your router’s MTU value.
z DNS
You can attain DNS automatically or specify a DNS server from DNS 1-3 that you wish to use.
z Clone MAC Address
Replace the WAN MAC address with the MAC address of that PC.
z Enable uPNP
Click the checkbox to enable uPNP function.
z Enable Web Server Access on WAN
Click the checkbox to enable web configuration from WAN side.
z Enable IPsec pass through on VPN connection
Click the checkbox to enable IPSec packet pass through.
z Enable PPTP pass through on VPN connection
Click the checkbox to enable PPTP packet pass through.
z Enable L2TP pass through on VPN connection
Click the checkbox to enable L2TP packet pass through.